What should be paid attention to when the engine hanger hoisting?

The engine crane should pay attention to safety first.
Secondly, pay attention to protect the engine during the hoisting process, and do not damage the engine and other accessories such as collisions.
Lifting the engine hanger requires special care and requires the cooperation of a team, because there are many parts on the engine body that need to be dismantled and separated. First, remove the negative pole of the battery, and then unplug the electrical plug and wiring harness, so as to avoid damage to the electronic control device.

When dismantling the cooling system, the water in the water tank must first be filled and released. The released water must be packed in a utensil, so as not to allow the water to drip on the ground, then dismantle the various water pipes. Put a basin to prevent water from dripping on the ground, and develop a good working habit until all the water pipes are separated from the engine, and then remove the cooling fan. When taking out the fan, be careful not to let the fan blades scratch the cooling fins.

To dismantle the lubricating system, first unscrew the oil cap, then screw the oil drain screw. When screwing the oil drain screw, hold the screw with your hand and feel that the screws are all unscrewed. Quickly remove the screw, so as to prevent the oil from getting dirty. Dirty hands, use the oil basin to release the oil. Then, use a special tool to unscrew the oil filter, check the cleanliness of the oil filter, and replace it if necessary.

When disassembling the sensing harness, it must be done under the condition of power failure. After disassembling, check it carefully to see if there is any leaking place. If there is, remove the undisassembled and mark it to avoid wiring recovery. When connecting the wrong line.

Remove the clutch and exhaust pipe section to make the engine completely independent, then remove the fixing screws connecting the engine support foot glue and the beam, and then connect the engine hook with iron, and use the boom to lift the engine out. It is not over until the engine is placed smoothly on the workbench and secured.